4.35V LG E1 - capacity tests at 4.35V and 4.20V

I've previously tested Sanyo UR18650ZTA and this time i've got anoother 4.35V cell - LG E1.

LG ICR18650 E1 4.35V Li-ion high voltage Li-HV 18650 battery cell capacity test

The battery was bought from my reliable supplier (Queen Battery) and tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A.

I've used version 3.0 of my battery holder based on 0.5mm thick pure copper terminals

I've followed all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle each battery was charged at standard charge current mentioned in its datasheet to charge end voltage. Before each discharging or charging i've held a 1-1.5hrs pause. The environment temperature was 23.0-24.5°C. To be sure in results i've done each test minimum twice (usually 3-4 times).

LG ICR18650 E1

The cell is marked as LGABE11865 0247I048AB .

The main specs from LG E1 datasheet (pdf):
Nominal energy: 12.0Wh
Minimum energy: 11.6Wh
Nominal voltage: 3.75V
Standard charge current: 0.93A (0.3C)
Maximum charge current: 1.55A (0.5C)
Charge cut-off current: 50mA (100mA used)
Charge end voltage: 4.35V
Max. continuous discharge current: 4.65A (1.5C)
Discharge cut-off voltage: 2.75V
AC impedance at 1KHz: ≤70mΩ
Max weight: 49g

Measured initial DC IR at 3.1A in fully charged condition was 56±3mΩ

Measured weight of the tested cell was 47.52g

LG E1 capacity test results
At 4.35V charge:

The nominal energy at 0.2C doesn't reach 12Wh declared and the capacity is a bit higher than 3000mAh. Look at the 5A curve - it's really a heavy load for this guy. I'd not discharge it at more than 2A.

At 4.20V charge:

At 4.2V charge the capacity goes down to 2600mAh. The character of curves remains the same, just the numbers get lower.

COMPARISON

Let's check how much we lose by using 4.2V charge instead of 4.35V.
At 0.2C/0.62A:

Here we lose 13% in capacity and 14% in energy.

At 2A discharge:

The same 13 and 14%.

At 5A:

We lose 12% in capacity and 13% in energy.

So in general we lose about 13-14%.

LG E1 didn't show any fantastic results. It's real capacity appears to be about 3000mAh and 5A discharge seems to be too much for this cell. E1 could be interesting for those who need a high voltage cell for low drain (up to 2A) applications.

Here is the video version of this review:

Check out my YouTube channel for batteries, chargers and other stuff reviews.

Sony VTC6 - a 3000mAh/30A monster in 18650 size

Sony US18650VTC6 (or just VTC6) is a high drain 18650 size Li-ion cell which supports discharge rate up to 15A if no temperature control is used and up to 30A with 80°C temperature cut. The battery was bought from my reliable supplier ( Queen Battery ) and tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A. I've used version 3.0 of my battery holder based on 0.5mm thick pure copper terminals I've all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle each battery was charged at standard charge current mentioned in its datasheet to charge end voltage. Before each discharging or charging i've held a 1-1.5hrs pause. The environment temperature was 23.0-24.5°C. To be sure in results i've done each test minimum twice (usually 3-4 times). Sony US18650VTC6 The c ell is marked a

Samsung 50E capacity test - 5000mAh or not?

Samsung INR21700-50E is a 21700 size cell which is being sold as 5000mAh one while in its official datasheet the capacity is mentioned as "Min. 4900mAh". I've tested it to find out it's real capacity. The battery was bought from my reliable supplier ( Queen Battery ) and tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A. I've used version 3.0 of my battery holder based on 0.5mm thick pure copper terminals I've followed all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle each battery was charged at standard charge current mentioned in its datasheet to charge end voltage. Before each discharging or charging i've held a 1-1.5hrs pause. The environment temperature was 23.0-24.5°C. To be sure in results i've done each test minimum twice (usually 3-4 times). S

Samsung 21700 battery battle: 50G vs 48G vs 50E

Samsung has a good lineup of 21700 Li-ion batteries and when i tested INR21700-50G i thought it would be interesting to test INR21700-48G cell too because the new batch of 48Gs came in green heat shrink tube (the version i tested before was gray). Then i added 50E results to comparison as they are very close in capacity and max discharge rate. The batteries were bought from Queen Battery which is my reliable supplier of genuine cells and tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A. 50G and 48G cells were tested using my battery holder v.4.0. A detailed video about it is available on my channel. I've followed all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle the battery was charged at standard charge current mentioned in its datasheet to charge end voltage. Before each discharging or char

3500mAh 18650 Li-ion cells' discharge capacity test (Sanyo NCR18650GA vs Panasonic NCR18650GA vs LG MJ1 vs Samsung INR18650-35E)

Hi guys! I’ve got four 3500mAh batteries from top manufacturers. I’ve tested and compared them. I think it’s interesting not only for me, but also for you, the guy who is reading this:) The cells were bought from Queen Battery , a Chinese supplier of genuine batteries, who specializes mainly on EV and eBike market. Queen Battery has a branch in Europe, but they also work with customers from Americas, Russia, etc… As always, I've tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A. I've followed all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle each battery was charged at standard current mentioned in its datasheet to 4.2V (cut-off at 0.1A, which is the lowest supported by EBC-A20). Before each discharging or charging i've held a 1-1.5hrs pause. The environment temperature was 20-

Samsung 40T - high drain 21700 Li-ion battery's capacity test

Hi guys! I've tested the Samsung INR21700-40T (35A) at up to 20A discharge (limited by my equipment). The battery was bought from my reliable supplier ( Queen Battery ) and tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A. I've used version 3.0 of my battery holder based on 0.5mm thick pure copper terminals I've followed all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle each battery was charged at standard charge current mentioned in its datasheet to charge end voltage. Before each discharging or charging i've held a 1-1.5hrs pause. The environment temperature was 23.5-24.5°C. To be sure in results i've done each test minimum twice (usually 3-4 times). Samsung INR21700-40T The c ell is marked as INR21700-40T SAMSUNG SDI 2I15 which mean s that the production d

Li-ion 21700: LG M50 5000mAh vs Samsung 48G 4800mAh discharge capacity test

Hi guys! I've tested two high capacity 21700 cells - LG M50 (5000mAh) and Samsung 48G (4800mAh). The latter i had already tested before and the re-testing of another cell showed almost no difference with previous test results. The M50 is a new cell which is being sold as 10A one, but in its datasheet the maximum discharge current is mentioned as 7.28A. Nevertheless i've also discharged it at 10A to look at it's behavior. The cells i've bought from Queen Battery . As always, I've tested with ZKETECH EBC-A20 and a self-made battery holder. It's a PC-connected battery tester supporting 4-wire measuring and discharging at up to 20A. I've used the v2.5 of my battery holder I've followed all the prescriptions of the IEC61960-2003 standard concerning battery's capacity measurement. Before each discharging cycle each battery was charged at standard current mentioned in its datasheet to charge end voltage (4.2V) (cut-off at 0.1A, which is th

Thunderheart Reviews

Search This Blog